This is one of four manuals I have downloaded recently.
Purchase was very straight forward and the authorising email arrived in about 4 hours.
The quality of the scan is good. Print is clear and square to the page edges.
The manual was exactly what I wanted and I found it nowhere else. Thanks!
Text excerpt from page 11 (click to view)
00000gb.fm5 Page 12 Wednesday, May 10, 2000 3:42 PM
DRAINING RESIDUAL WATER
WHEN TO DRAIN RESIDUAL WATER
If the filter needs to be cleaned during a programme. Note: Make sure that the water has cooled before draining. Note: There can be up to 20 litres of water in the machine. � When transporting or moving the machine. � If there is danger of freezing in the installation room. In this case the machine and the hoses should be drained after every wash. � 5. Wait until the flow stops. Note: There can be up to 20 litres of water in the machine during a programme. 6. Clip the drain hose again on the rear part of the machine. 7. Replace the drain hose with the �U� bend and fix it.
DRAINING RESIDUAL WATER
1. Switch off the appliance. 2. Unplug the machine from the mains. 3. Unclip the drain hose connection on the rear part of the machine (see arrow). 4. Lower the drain hose into a container and let the water drain. Note: Make sure that the water has cooled before draining.
WASHING MACHINE INSTALLED IN ROOM EXPOSED TO FREEZING TEMPERATURES
Drain residual water from the machine, and the inlet hose after every wash cycle. 1. Switch off the appliance. 2. Unplug the machine from the mains. 3. Close the tap, loosen the inlet hose from the machine and let the water drain out. 4. Open the filter, let the water drain out and close it again. Note: Before a new wash cycle screw the inlet hose to the machine by hand. Check watertightness of washing machine connections by turning the tap completely on.
